This is Micro Manufacturing's "New" Motherboard, software to install in your GT2001/GT2002.
These instructions encompass both the countertop and upright models.
READ THIS PROCEDURE ENTIRELY SO YOU ARE COMPLETELY FAMILIAR WITH THE OVERALL PROCEDURE BEFORE YOU START.
Note: This installation requires a CD-ROM with a speed of 4X or higher.
Remove the 531CF Motherboard and Install the new 630TCF Motherboard before CD-Driver installation
Step 1: To access the electronics tray with the CD-ROM connection, open the front black cover of the game.
Step 2: Pull out the out the electronics tray and secure it in a horizontal position. (Picture 01)
pic01Step 1: Remove the blue or black back cover from the game and place to the side for re-installation latter. Put the cover on a protective surface to prevent scratching of the painted finish. The CD-ROM connection is located at the back center of the game.
pic02
pic03Step 1: Make sure the power is off to the game
Step 2: After you have gained access to the electronics tray in either the upright or countertop games locate the CD-ROM connector. Refer to Pic 01 for the upright and pictures 02 & 03 for the countertop. The CD-ROM cable is a gray 40-pin ribbon cable. The countertop model may have either of two connection points, verify which connection point you have by referring to Pic 02 and Pic 03
Step 3: Install a 40 pin ribbon cable into the customer supplied CD-ROM and then into the CD-ROM connection point on the game. The CD-ROM ribbon cable will only fit into the connector one way and that is with the red stripe facing the same direction as on the game. Make sure that the red stripe is facing the power connection side on the customer supplied CD-ROM.
Step 4: Plug the 4 Pin AMP connector into the customer supplied CD-ROM. The square 4-pin connector plugs into the game. Refer to Pic 01 for the upright power connector location and Pic 02 and Pic 03 for the countertop power connector location.
Step 5: Turn main power on.
Step 6: Open your CD-ROM access door and place the CD into the compartment.
(Do not close compartment)
Step 7: Turn main power off. (Wait 5 seconds) then turn the main power on, the CD-ROM door will
close and begin installing your new software. This procedure will take approximately 2 minutes.
Step 8: When software installation is complete,
Open the CD-ROM door and remove the CD from your CD-ROM drive.
Step 9: Turn main power off and disconnect the CD-ROM drive, the 40-pin ribbon cable
And the CD-ROM power cable from the game.